Ruggedcom RSG2300 Manuale Utente Scaricare il pdf (Pagina 21)

3. Installation

RuggedCom® RuggedSwitch® 21 RSG2300 Installation Guide Rev 110

Figure 3.21. Failsafe Alarm Relay Wiring

3.2.6. Console Port Wiring

An RS232 console port for configuration and management of the device is located on the LED

display module shown in Figure 3.22, “Console Port on Display Board”. This port is intended to

be a temporary connection during initial configuration or troubleshooting and allows direct serial

access to the management console. The connection is made using the DB9-Female to RJ45

console cable included in the device packaging shown in Figure 3.23, “RS2000 Series Console

Cable”. Console connection settings are: 57600 bps, no parity bits, 8 data bits, and 1 stop bit.

Figure 3.22. Console Port on Display Board

Figure 3.23. RS2000 Series Console Cable

Signal Name (PC is DTE) DB9- Female RJ45 Male

DCD – Carrier detect 1 2

RxD – Receive data (to DTE) 2 5

TxD – Transmit data (from DTE) 3 6

DTR – Data terminal ready 4 3

GND - Signal ground 5 4

DSR – Data set ready 6 1*

RTS – Ready to send 7 8

CTS – Clear to send 8 7

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Nessun commento

Ruggedcom RSG2300 Manuale Utente Pagina 21